PB Model PB-50
Tank STD
Horsepower 1.5 hp
Factory Wired 208/230 V
Phase 1
Starter Panel No
Shipping Weight 200 lb
Frequence 60 Hz
Connection Size Inlet 1.25 in
Connection Size Outlet 1.5 in
Length 41.5 in
Width 22.5 in
Height 41 in
Tank Vol. 40 gal
Tank Acc. 0.75
Max. Flow 50 gal
Max. Regulated Boost 35 psig
Min. Suction Press. 5 psig
Pressure Switch Range 20 - 80 psig
Factory Differential Setting 20 psig
Pump cut-in 20 psig
Pump cut-out 40 psig
Factory PRV Discharge Setting 30 psig
Factory Tank Pre-charge 18 psig
Maximum Operating Conditions 125 psig at 120 °F
Pump Model 1 X 1.25 X 5 GTU
PRV Model Thrush 1.5 in Boostrol
Electrical Standard 208/230V/60Hz/1Ph
Electrical Optional 115V/60Hz/1Ph
Tank Model DWT-150V, 40 Gallon
Tank Diaphragm Heavy Duty Butyl, NSF-61 Approved
Tank Liner & Exterior Corrosion resistant epoxy
Skid Material Formed steel, powder coated
PB SERIES Pressurizers can be pre-set to non-standard settings for $419.00 list.
Single Phase PB-50's can be field rewired to 115/60/1.
Connection size is not recommended pipe size. Piping should be sized to allow adequate flow and minimal pressure loss.
Model is equipped with low suction switch.
Pressurizers with Starter Panels CANNOT be converted from 1 Ph. To 3 Ph. Or from 3 Ph. To 1 Ph.
Pressurizers with Starter Panels can be converted from their catalog voltage to another catalog voltage with proper components from Thrush.
PB SERIES Pressurizers requiring TEFC motors and/or NEMA 4 panels must be quoted. Please contact customer service for a quote.